The information in the chart below can be used to assist with the identification of the most appropriate coupler. For more detailed information please select a range from the menu on the left.
|Type||Type A||Type B||Type C|
|Bar Dia. mm||12-50||12-50||12-50|
|Bar End Prep||Threaded||Threaded||Threaded|
|Capacity||Full Strength up to 650MPa|
|Bar Dia. (mm)||12-50|
|Bar End Prep||Threaded|
|Capacity||Full strength up to 650MPa|
|Bar Dia. mm||10-50||10-40||10-40|
|Bar End Prep||No||No||No|
|Installation||Wrench or Nut Runner|
|Capacity||Full Strength up to 575MPa|
*This section is subject to change and you are advised to contact your local Ancon sales office to discuss any project-specific requirements.
Ancon is a proud sponsor of the 5th International fib Congress taking place in Melbourne, Australia, from 7th to 11th October and expecting to attract 700 delegates from over 40 countries.
Available exclusively in Australia from Ancon, HALFEN HTA Anchor Channels demonstrate compliance with Australian Standard AS5216 ‘Design of Post-installed and Cast-in Fastenings’ through a new European Technical Assessment (ETA).